How to Install an Ice Maker Water Line


Set up of an ice maker water line is a reasonably easy process {that a} handyman can full in an hour or two if they’ve somewhat data and the proper set of instruments. Nonetheless, there are some things that may go awry and trigger injury to your own home if not achieved correctly. Even some particular set up kits and instruments can lead you within the improper course, inflicting leaks sooner or later.

Putting in an ice maker water line is a straightforward job to do by your self. Prior to now, you would solely use a ¼” copper pipe to attach the ice maker to the closest supply of water, as of late there are ¼” flex pipes that come in numerous lengths from 1′ to twenty’ that you should use to connect with any water supply. You solely have to calculate how far your water line will have to be run to be able to purchase the pipe with the proper size.

Most individuals run water traces by their cupboards and over the fridge, but when that’s not attainable, then you definately might need to have a look at working the road by the ground. Most fashionable ice makers have a provide valve, which makes working an exterior ice maker water line simple.

If in case you have a water provide

All you’ll need to do is to purchase a brief 1/4″ by 1/4″ flex line and join it to the again of the ice maker after which to the supply of water. Upon getting achieved that flip the water on and test for any leaks alongside the road.

If you do not have a water provide

If you want to add a water provide use both a brand new 3-way angle stops or add Adapt-A-Tee. There are Adapt-A-Tees which are out there from most plumbing shops that you should use. They’re fast to put in and require much less work than most. Listed below are a number of steps you can observe to put in a brand new ice maker water line when there is no such thing as a water provide:

– Find the angle cease round or beneath the sink space the place you can be tying the road. Shut the tap and shut off water to the angle cease.

– Just be sure you disconnect the flex line working from the angle cease. You might need to make use of two units of pliers to take away the road safely. Pliers ought to be used to connect the angle cease and maintain it in place, and the opposite ought to be used to unscrew the flex line.

– Now, you’ll be able to connect the Tee Adapter. The adapter ought to connect with the water cease valve and it ought to be sized to suit the valve. The vital factor is to ensure that the outlet has ¼” OD.

– Tighten the Adapt-A-Tee to the angle cease. Tighten it as a lot as you’ll be able to and use a wrench if it’s important to however watch out to not transfer the angle cease while you might be tightening.

– Reconnect the water provide line to the three/8″ finish of the Adapt-A Tee. Maintain it as you tighten the road connection.

– Join the ¼” flex line to the Adapt-A-Tee and tighten.

To attach the flex line working from the water supply these are the steps it’s best to observe:

– Take the opposite finish of the ¼” flex line and join that to the ice maker. Tighten it utilizing pliers to ensure that there are not any leakages at that finish.

– As soon as the connections to the cease valve beneath your sink have been secured, open the faucets on and run water by.

– Examine for leaks in any respect the connection factors and alongside the road. If there are not any leaks, your ice maker water line was efficiently run and now you can put the ice maker again. You’ll have to let the water line installation run by the ice maker or water dispenser (in case you have one). You will have to do that to flush the road and dispenser clear in addition to to take away any air trapped alongside the road. Use the water dispenser to do that. When you shouldn’t have a water dispenser you want to throw out the primary full batch of ice that comes by the ice dispenser to ensure that the ice is clear.


Leave a Reply

Your email address will not be published. Required fields are marked *